When Your Dental Software and Your Bank Never Agree
By Chris Kimbell · · 3 min read

You finish a long day of patients. The schedule was full. Your dental software says production was strong this month.
Then you look at the bank, and it tells a smaller story. And when you open the books, they tell a third one.
If you own a dental office, you know this feeling. Three numbers that should agree, and never do.
Why the numbers never line up
Your practice management software counts production. That's the work your team did and the fees attached to it. It's the number that feels like your month.
The bank only sees collections. That's the money that actually arrived. Insurance pays weeks later, and often less than the fee. Patients pay their part at the visit, or in a few weeks, or after a reminder or two.
Then there are adjustments. The difference between your fee and what an insurance plan allows has to go somewhere. If nobody records it the same way every month, production and collections drift further apart and nobody can say why.
So you end up with a big number in the software, a smaller number in the bank, and books that may match neither.
The part that wears on you
The hard part isn't the math. It's not being able to trust any of it.
You can't tell if a slow month at the bank is a real problem or just insurance running late. You can't tell if your office manager's collection work is paying off. You can't tell whether that new hygienist is covering their cost yet, because the numbers you'd use to check don't agree with each other.
So you stop looking. You go by feel. And dentistry is already a job full of small decisions. Guessing about money on top of that is exhausting.
Where it usually goes wrong
In most small offices, it comes down to a few habits.
- Insurance deposits land in the bank as one lump sum, and nobody ties them back to the claims they paid.
- Adjustments get handled differently depending on who's at the front desk that day.
- Patient balances sit for months, and nobody looks at the aging report until it's long.
- The books get updated from bank deposits only, so they show collections but have no idea what was produced.
None of this means anyone is doing a bad job. It means the software, the bank, and the books were never set up to talk to each other.
What actually helps
There's no magic report that fixes this. What helps is a steady monthly routine.
Each month, production, adjustments, and collections get pulled from your dental software and lined up against the bank. Insurance deposits get matched to the claims behind them. The gap between what you produced and what you collected gets explained, not just noticed.
After a few months of that, the three numbers start to make sense together. A slow deposit month stops being scary because you can see the claims still out. You can ask real questions again, like whether a certain plan is worth staying in network with.
If production versus collections sounds a lot like accrual versus cash, it is. We cover that idea in cash or accrual bookkeeping for a Montana business, and it applies to dental offices just as much as seasonal trades.
A good time to start
Year-end is a natural point to get this lined up, since you're already looking back at the full year. Our year-end bookkeeping checklist for Montana business owners is a good place to begin.
Blackfin works with dental offices and other service businesses around Bozeman. We keep bookkeeping and tax prep under one roof, so the people sorting out your production and collections also know what your return will need. If you'd like a hand, look at our monthly bookkeeping for Bozeman service businesses or call 406-404-8955. You'll hear back within one business day.
This article is general information, not tax, legal, or investment advice. Every business is different, so call us at 406-404-8955 to talk about yours.

Chris Kimbell, Founder of Blackfin Accounting
About Chris and Blackfin

